Western Star Detroit engine · Dawson Creek, BC · Kiskatinaw Hill · 2026-11
Call (855) 450-1212Request a quote["rad hose leak","engine derated","limp mode","engine shut down"]
When a radiator hose comes loose or leaks coolant on a Detroit engine, the ECM detects rapid coolant loss and high engine temperatures. To protect the engine from severe internal damage like blown head gaskets or warped heads, the ECM triggers a derate into limp mode before automatically shutting the truck down.
If this happens on the road, safely pull over and let the engine cool completely before opening the hood. Inspect the upper and lower radiator hoses, clamps, and fittings for pops, tears, or loose hose clamps. If a clamp simply slipped off, reattaching the hose and tightening the clamp may fix the leak, but you must refill the cooling system with the proper coolant blend before attempting a restart. Never run the engine dry.
Even after repairing the hose and topping off coolant, modern Detroit engines often latch active low coolant and engine temperature fault codes. While some shutdown codes clear after heat levels normalize and coolant level sensors register full, severe derates require a technician with diagnostic software to clear the latched codes and reset the engine status. If the engine overheated severely or refuses to start after refilling coolant, call a mobile diesel mechanic or request a tow to avoid catastrophic engine damage.
Driver reported a rubber radiator hose clamp came undone on a Detroit engine, leaking coolant and causing the truck to derate into limp mode and shut off.
unknown
Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.
A leaking wheel seal on a drive axle is a serious issue that requires prompt attention to prevent damage to the wheel end bearings and brake components. When a wheel seal fails, axle lubricant seeping out can sling onto the rim, tire, and brake shoes. If oil …
A derate accompanied by a flashing red light on a 2021 Peterbilt 579 with a PACCAR engine indicates the engine control module has detected a severe fault or critical emissions condition. The most common cause is an aftertreatment system failure, such as a clo…
When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…
When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…
123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com
Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.