123 TRACTOR & EQUIPMENT REPAIR(855) 450-1212 · Field service 24/7

My Volvo 670 won't start after the ignition was left on and drained the batteries, what should I check?

Volvo 670 · 2026-11

Call (855) 450-1212Request a quote

What was reported

["battery drained","truck won't start","ignition left on"]

Our answer

When a heavy-duty truck like a Volvo 670 won't crank after the key or accessories were left on, the most common issue is simple battery depletion. Leaving the ignition switched on powers up the main ECM, dash lights, and cab electronics, which quickly drains the battery bank overnight or over several hours. Before requesting a technician, turn off all electrical loads such as cab lights, inverter, HVAC blower, and radios. Inspect the battery cables at the frame and battery posts for loose connections, heavy corrosion, or swollen battery cases. If the voltage has dropped too low, the starter solenoids will only click or fail to respond entirely. On modern Volvo trucks with automated transmissions, low system voltage can also prevent the transmission controller from authorizing a start. A standard light-duty vehicle jump pack usually lacks the amperage required to turn over a heavy diesel engine. A mobile technician equipped with a high-output commercial jump unit or auxiliary charger can safely boost the battery bank, check alternator charging voltage once running, and test individual batteries for dead cells.

What the technician found

Ignition was left on, causing the batteries to drain completely; truck required a heavy-duty jump start.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why did my 2019 Freightliner Cascadia batteries die after sitting for a few days?

2019 Freightliner Cascadia · 2026-11

When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…

Why does my truck start up and die immediately when a diagnostic scanner cannot connect to the ECM?

2026-11

When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…

Why is my semi truck scanner failing to connect to the computer and the truck shuts down after starting?

2026-11

When a heavy-duty diagnostic tool cannot establish communication with the engine control module and the truck shuts down right after starting, the issue usually stems from a primary power, ground, or databus communication failure. First, inspect the main batt…

Why is coolant leaking under the DEF tank on my Freightliner truck?

Freightliner · 2026-11

A coolant leak underneath the DEF tank on a Freightliner is usually caused by failing DEF tank heater coolant lines, worn quick-disconnect fittings, or a faulty DEF heater control valve. Heavy-duty trucks route engine coolant directly to the DEF tank assembly…

What should I do if my semi truck wheel hub assembly fails on the road?

2026-11

A failing semi truck wheel hub assembly often starts with leaking hub oil around the cap or inner seal, excessive play in the wheel, grinding noises, or high temperatures at the wheel end. If you notice hub oil leaking onto the wheel or rim, check the hub cap…

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (855) 450-1212Quote