123 TRACTOR & EQUIPMENT REPAIR(855) 450-1212 · Field service 24/7

Why are my trailer running lights and strobe lights not working when brake and turn signals work?

2026-11

Call (855) 450-1212Request a quote

What was reported

["trailer running lights not working","trailer strobe lights not working","brake lights and signal lights working"]

Our answer

When a trailer's brake lights and turn signals work fine but the running lights and strobe lights fail to illuminate, the issue usually points to the specific tail and marker light circuit rather than a main ground failure. The most common cause is a loose, corroded, or damaged pin on the seven-way electrical cord or tractor receptacle, specifically the pin dedicated to the clearance and running light circuit. Another frequent culprit is a blown fuse or tripped circuit breaker in the tractor fuse panel powering the trailer marker light circuit. Wiring harness damage, such as a pinched or chaffed wire running along the trailer frame, or corrosion inside a junction box feeding the running and strobe light circuits can also cut power to those specific lights. As a driver, start by inspecting the seven-way plug and receptacle for green corrosion, bent pins, or loose fit. Try wiggling the cord while someone watches the lights, or swap in a spare seven-way cord if available. Next, check the tractor fuse box for any blown fuses corresponding to trailer clearance or tail lights. If the plug and fuses look good, a mobile technician will need to trace the wiring with a multimeter or circuit tester to locate open circuits, shorted wires, or bad connections along the trailer chassis.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why did my 2019 Freightliner Cascadia batteries die after sitting for a few days?

2019 Freightliner Cascadia · 2026-11

When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…

Why does my truck start up and die immediately when a diagnostic scanner cannot connect to the ECM?

2026-11

When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…

Why is my semi truck scanner failing to connect to the computer and the truck shuts down after starting?

2026-11

When a heavy-duty diagnostic tool cannot establish communication with the engine control module and the truck shuts down right after starting, the issue usually stems from a primary power, ground, or databus communication failure. First, inspect the main batt…

Why is coolant leaking under the DEF tank on my Freightliner truck?

Freightliner · 2026-11

A coolant leak underneath the DEF tank on a Freightliner is usually caused by failing DEF tank heater coolant lines, worn quick-disconnect fittings, or a faulty DEF heater control valve. Heavy-duty trucks route engine coolant directly to the DEF tank assembly…

What should I do if my semi truck wheel hub assembly fails on the road?

2026-11

A failing semi truck wheel hub assembly often starts with leaking hub oil around the cap or inner seal, excessive play in the wheel, grinding noises, or high temperatures at the wheel end. If you notice hub oil leaking onto the wheel or rim, check the hub cap…

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (855) 450-1212Quote