123 TRACTOR & EQUIPMENT REPAIR(336) 285-0796 · Field service 24/7

Why did my semi truck stall and refuse to start after driving in reverse up a steep slope?

Charlotte, NC · 2026-11

Call (336) 285-0796Request a quote

What was reported

["engine stalled on incline","truck won't start","driving in reverse uphill","suspected low fuel level"]

Our answer

When a heavy-duty diesel truck stalls and refuses to start after driving on a steep incline or backing up a hill, the most common cause is a low fuel level allowing air to enter the fuel system. When the fuel tank is low, severe angles cause fuel to slosh away from the suction pickup tube. The fuel pump then draws air instead of fuel into the supply lines, causing the engine to starve and die. A driver can safely check the fuel tank level first. If the fuel is low, adding several gallons of fresh diesel is necessary. However, simply adding fuel often won't immediately start the truck because air is trapped in the lines. The fuel system must be primed using the hand primer pump or an electric priming pump while cracking open the filter drain or bleed valve to purge air. If the engine still refuses to start after adding fuel and thoroughly priming the system, a professional technician should inspect the fuel lift pump, check for clogged fuel filters, and verify rail pressure with diagnostic tools.

What the technician found

The technician suspected low fuel level caused fuel to slosh away from the tank pickup tube while driving on an incline, pulling air into the system. Planned to add diesel and attempt to prime and start the engine.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

My semi truck ran out of fuel and now cranks but won't stay running after adding diesel, how do I get it started?

Charlotte, NC · 2026-11

When a heavy-duty semi truck runs completely out of diesel, putting just five gallons into each tank often is not enough fuel to submerge the pickup tubes, especially if the truck is parked on a slight incline. The most common reason a truck cranks but will n…

Why is my 2006 Freightliner M2 cranking but not starting after filling up with diesel?

2006 Freightliner M2 · Charlotte, NC · 2026-11

When a 2006 Freightliner M2 cranks but fails to start right after refueling, the most common issue is air trapped inside the fuel system, especially if the tank was run completely dry before fill-up. Another frequent cause is a failed primer pump, a severely …

Why did my 2020 Freightliner Cascadia DD15 suddenly lose all oil pressure while the engine was running fine?

2020 Freightliner Cascadia DD15 · LaGrange, NC · 2026-11

When a Detroit DD15 engine suddenly shows zero oil pressure on the dash gauge while running smoothly with a full oil level on the dipstick, the issue is often electronic rather than an immediate loss of oil. The most common culprit on Freightliner Cascadias i…

What should I do if a drive axle wheel seal is leaking onto my rim and tire on a Kenworth T680?

2023 Kenworth T680 · Baltimore, MD · 2026-11

A leaking wheel seal on a drive axle is a serious issue that requires prompt attention to prevent damage to the wheel end bearings and brake components. When a wheel seal fails, axle lubricant seeping out can sling onto the rim, tire, and brake shoes. If oil …

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (336) 285-0796 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (336) 285-0796Quote