123 TRACTOR & EQUIPMENT REPAIR(855) 450-1212 · Field service 24/7

What should I do if the coolant hose off the back of my Cat engine water pump is leaking on the highway?

Peterbilt 379 Cat engine · I-440 · 2026-11

Call (855) 450-1212Request a quote

What was reported

["coolant leaking","leaking water hose behind water pump"]

Our answer

When a coolant hose behind the water pump starts leaking on a Caterpillar engine, immediate action is required to prevent severe engine overheating. A leaking hose in this area can cause rapid coolant loss, leading to blown head gaskets or cylinder head damage if the engine operates without adequate coolant flow. The primary causes of water pump hose failures include thermal degradation, age, high cooling system pressure, or chafing against engine brackets. If you notice coolant leaking near the water pump on the shoulder, shut down the engine immediately. Allow the cooling system to cool down completely before inspecting the area. Check the hose off the back of the water pump for splits, soft spots, swelling, or loose hose clamps. Never attempt to remove a hot radiator cap or pressurized hose. If a loose clamp is the issue, tightening it and topping off with proper coolant might allow safe travel to a shop. However, if the hose is split or ruptured, a mobile technician is needed to replace the hose, refill and bleed the cooling system, and perform a pressure test before you get back on the road.

What the technician found

Customer reported a leaking water hose coming off the back of the water pump on a Caterpillar engine; photos were requested to source and dispatch the exact replacement hose.

How it ended

fixed on site

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why did my 2019 Freightliner Cascadia batteries die after sitting for a few days?

2019 Freightliner Cascadia · 2026-11

When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…

Why does my truck start up and die immediately when a diagnostic scanner cannot connect to the ECM?

2026-11

When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…

Why is my semi truck scanner failing to connect to the computer and the truck shuts down after starting?

2026-11

When a heavy-duty diagnostic tool cannot establish communication with the engine control module and the truck shuts down right after starting, the issue usually stems from a primary power, ground, or databus communication failure. First, inspect the main batt…

Why is coolant leaking under the DEF tank on my Freightliner truck?

Freightliner · 2026-11

A coolant leak underneath the DEF tank on a Freightliner is usually caused by failing DEF tank heater coolant lines, worn quick-disconnect fittings, or a faulty DEF heater control valve. Heavy-duty trucks route engine coolant directly to the DEF tank assembly…

What should I do if my semi truck wheel hub assembly fails on the road?

2026-11

A failing semi truck wheel hub assembly often starts with leaking hub oil around the cap or inner seal, excessive play in the wheel, grinding noises, or high temperatures at the wheel end. If you notice hub oil leaking onto the wheel or rim, check the hub cap…

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (855) 450-1212Quote