123 TRACTOR & EQUIPMENT REPAIR(541) 449-7122 · Field service 24/7

Why did my Kenworth T680 die after hitting a bump and now cranks but won't start?

Kenworth T680 PACCAR engine · Highway 46 · 2026-11

Call (541) 449-7122Request a quote

What was reported

["engine died after going over bump","DEF gauge dropped to zero","cranks but will not start"]

Our answer

When a Kenworth T680 with a PACCAR engine suddenly dies after hitting a bump and the DEF gauge drops to zero while the engine cranks without starting, the problem is almost always electrical. A hard impact can unseat a loose wiring connector, break a corroded ground strap, or dislodge a relay or fuse in the main power distribution module. Because the DEF gauge dropped to zero while the starter still turns the engine over, the engine control module or multiplexed dash system likely lost main battery power or CAN bus communication. A driver can safely perform a quick visual inspection under the hood and at the battery box. Check that all battery terminal cables are tight and free of severe corrosion. Open the main electrical panel to ensure all relays and fuses are firmly seated, paying close attention to the ECM power and ignition fuses. Inspect the main wiring harnesses along the frame rails and firewall for loose harness connectors or pinched wires. If fuses continue to blow or visible connections are secure, a heavy-duty technician is needed to hook up diagnostic software, verify ECM power circuits, and trace the communication fault.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

My engine started making a nasty knocking sound on the highway and shut down automatically, and now it will not start.

2018 Freightliner · Pendleton, OR · 2026-11

A sudden, severe knocking sound followed by an automatic engine shutdown on a heavy-duty truck usually indicates major internal engine mechanical failure. Common causes include a spun rod or main bearing, a damaged wrist pin, a dropped valve, or severe lubric…

What should I do if a drive axle wheel seal is leaking onto my rim and tire on a Kenworth T680?

2023 Kenworth T680 · Baltimore, MD · 2026-11

A leaking wheel seal on a drive axle is a serious issue that requires prompt attention to prevent damage to the wheel end bearings and brake components. When a wheel seal fails, axle lubricant seeping out can sling onto the rim, tire, and brake shoes. If oil …

Why is my 2021 Peterbilt 579 derating with a red warning light flashing on the dash?

2021 Peterbilt 579 PACCAR · Mauston, WI · 2026-11

A derate accompanied by a flashing red light on a 2021 Peterbilt 579 with a PACCAR engine indicates the engine control module has detected a severe fault or critical emissions condition. The most common cause is an aftertreatment system failure, such as a clo…

Why did my 2019 Freightliner Cascadia batteries die after sitting for a few days?

2019 Freightliner Cascadia · 2026-11

When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (541) 449-7122 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (541) 449-7122Quote