123 TRACTOR & EQUIPMENT REPAIR(855) 450-1212 · Field service 24/7

How do I deal with a leaking engine hose and loose bolts after a recent repair?

Kenworth · 2026-11

Call (855) 450-1212Request a quote

What was reported

["leaking engine hose","wet trail under engine","loose bolts after kingpin replacement"]

Our answer

When you notice a wet trail or leaking hose under the hood near the engine, it often points to a blown or deteriorated coolant jumper hose, bypass line, or high-temp pressure hose. Heat cycling and constant vibration can degrade small extension hoses, causing them to crack or blow off fittings. At the same time, finding loose hardware after recent front-end work, such as kingpin replacements, is a serious safety hazard that can cause steering binding, misalignment, or severe component damage.

First, check your coolant level and avoid running the engine if fluid loss is significant to prevent overheating. Inspect the leaking hose for its exact diameter, length, and fitting type, or obtain the OEM part number using your truck VIN through a dealer parts counter. For loose steering or suspension hardware, check if bolts are missing or stripped, but do not operate the vehicle until all fasteners are torqued to manufacturer specifications.

If you cannot source the exact OEM hose or safely torque critical steering bolts on the road, contact a mobile diesel mechanic. A technician can supply the correct high-temperature hose, top off fluids, and properly torque all loose hardware on site to get you rolling safely.

What the technician found

Found a leaking 5 to 6-inch engine pressure hose and two loose bolts left untightened from a previous kingpin replacement.

How it ended

parts needed

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why did my 2019 Freightliner Cascadia batteries die after sitting for a few days?

2019 Freightliner Cascadia · 2026-11

When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…

Why does my truck start up and die immediately when a diagnostic scanner cannot connect to the ECM?

2026-11

When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…

Why is my semi truck scanner failing to connect to the computer and the truck shuts down after starting?

2026-11

When a heavy-duty diagnostic tool cannot establish communication with the engine control module and the truck shuts down right after starting, the issue usually stems from a primary power, ground, or databus communication failure. First, inspect the main batt…

Why is coolant leaking under the DEF tank on my Freightliner truck?

Freightliner · 2026-11

A coolant leak underneath the DEF tank on a Freightliner is usually caused by failing DEF tank heater coolant lines, worn quick-disconnect fittings, or a faulty DEF heater control valve. Heavy-duty trucks route engine coolant directly to the DEF tank assembly…

What should I do if my semi truck wheel hub assembly fails on the road?

2026-11

A failing semi truck wheel hub assembly often starts with leaking hub oil around the cap or inner seal, excessive play in the wheel, grinding noises, or high temperatures at the wheel end. If you notice hub oil leaking onto the wheel or rim, check the hub cap…

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (855) 450-1212Quote