Kenworth · Drumbo, ON · Hwy 401 · 2026-11
Call (855) 450-1212Request a quote["coolant line leaking","damaged line coming off reservoir"]
Coolant lines coming off a Kenworth expansion tank or overflow reservoir frequently fail due to constant engine vibration, thermal expansion, and aging rubber or plastic fittings. The most common causes are a split hose end, a cracked plastic fitting at the reservoir neck, or a loose hose clamp. If you notice coolant leaking from this upper overflow hose, pull over safely and let the engine cool down completely before inspecting it. Never attempt to remove or adjust coolant lines or cap while the system is hot and pressurized. Once cool, inspect the hose end for splits. If there is sufficient slack in the hose, you can sometimes cut off the damaged inch of rubber and re-clamp it tightly over the nipple as a temporary fix to reach safety. However, if the plastic nipple on the surge tank itself is cracked or broken off, the reservoir or fitting must be replaced. A mobile diesel technician can pressure test the cooling system, replace split silicon or rubber hoses, and replenish the coolant safely on site.
Coolant line coming off the reservoir was leaking or damaged.
unknown
Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.
A leaking wheel seal on a drive axle is a serious issue that requires prompt attention to prevent damage to the wheel end bearings and brake components. When a wheel seal fails, axle lubricant seeping out can sling onto the rim, tire, and brake shoes. If oil …
A derate accompanied by a flashing red light on a 2021 Peterbilt 579 with a PACCAR engine indicates the engine control module has detected a severe fault or critical emissions condition. The most common cause is an aftertreatment system failure, such as a clo…
When a 2019 Freightliner Cascadia sits idle for four or five days, parasitic electrical draws can easily drain the battery bank below the threshold needed to crank the engine. Modern trucks run continuous background electronics, including fleet telematics, EC…
When a heavy-duty truck starts briefly and dies immediately while a diagnostic scanner cannot establish communication with the ECM, the problem usually stems from a loss of power, ground, or data bus signals to the engine control module. The most common cause…
123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com
Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.