123 TRACTOR & EQUIPMENT REPAIR(385) 449-1243 · Field service 24/7

Why is only one windshield wiper getting stuck and slipping on my 2017 Peterbilt?

2017 Peterbilt Cummins ISX · Tremonton, UT · 2026-11

Call (385) 449-1243Request a quote

What was reported

["one windshield wiper getting stuck","wiper arm screw loosening up","wiper moves intermittently while other side works fine"]

Our answer

When only one windshield wiper on a semi-truck gets stuck or stops moving while the opposite side operates normally, the wiper motor itself is usually fine. The problem almost always lies within that specific wiper arm socket, mounting bolt, or linkage assembly. A very common issue is a loose or stripped wiper arm retaining nut at the pivot shaft. Over time, the internal splines on the soft aluminum wiper arm socket can strip out, allowing the motor shaft to spin freely while the arm stutters or stops. oversized wiper blades can also add excessive drag against the glass, causing the set screw to back out or mechanical linkage to bind. Drivers can safely check whether the nut securing the base of the wiper arm is tight and verify that the blade size matches OEM specifications. Inspecting the arm splines for wear is also a quick check. If tightening the nut does not resolve the issue or the linkage arm beneath the cowl is bent or disconnected, a mobile technician will need to inspect the wiper transmission and replace damaged components to ensure clear visibility on the road.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why is my 2020 Freightliner making a loud air hiss sound from the engine under acceleration with no fault codes?

2020 Freightliner Cummins X15 · Corinne, UT · 2026-11

When a 2020 Freightliner with a Cummins X15 engine makes a loud air hissing or rushing exhaust sound under acceleration without throwing check engine codes, the issue is typically a high-pressure air boost leak or a loose exhaust component. The most common cu…

Why did my Cummins diesel engine make a loud popping noise, blow heavy black smoke, and shut down?

Cummins engine · St. George, UT · 2026-11

A sudden popping noise followed by heavy black smoke and engine shutdown on a diesel truck strongly points to a severe air-intake or turbocharger failure. The most common cause is a blown turbocharger or a failed variable geometry turbo actuator, which disrup…

Why can't a ruined trailer spindle and wheel bearing be replaced on the roadside?

reefer trailer · Aragonite, UT · 2026-11

A severe trailer wheel bearing failure can generate intense heat, causing the inner and outer bearings to disintegrate and gall or weld onto the axle spindle. Common causes include failed hub seals leading to oil starvation, improperly set spindle nut endplay…

What should I do if a drive axle wheel seal is leaking onto my rim and tire on a Kenworth T680?

2023 Kenworth T680 · Baltimore, MD · 2026-11

A leaking wheel seal on a drive axle is a serious issue that requires prompt attention to prevent damage to the wheel end bearings and brake components. When a wheel seal fails, axle lubricant seeping out can sling onto the rim, tire, and brake shoes. If oil …

All real calls

123 Tractor & Equipment Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (385) 449-1243 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Brand names on this site are used only to describe the equipment we work on. We are an independent service, not a dealer, and are not affiliated with or endorsed by any equipment manufacturer.

Call (385) 449-1243Quote